[. . . ] The instructions below assume that the unit has no other attachments that interfere with the cutter installation. [. . . ] Ensure appropriate grounding measures are taken before beginning any activity inside the printer. Remove the two screws (3) securing the front cover (4) to the cover hinge (5). If the peeler (6) is present, remove the screw (7), then move the peeler to the right and lift it (6) off. Remove the power switch (8) from the housing (9) and disconnect its leads. Place the cutter assembly (15) in the face of the printer chassis (16) and secure it to the upper right corner using the screw (17). NOTE: When properly installed, the tab of the cutter assembly bracket will insert into the slot of the printer chassis and the cutter will nest there as the peeler cover prior to removal. Ensure print media and ribbon are properly loaded in the printer, then lower the print assembly and latch in position. Close the cover, connect the power supply cord, and turn the printer on. [. . . ] Ensure print media and ribbon are properly loaded in the printer, then lower the print assembly and latch in position. [. . . ]